2009 Chevrolet Tahoe Cigarette Lighters

While depressing the lock, remove the connector from the component. You need to locate the two indents of the terminal position assurance (TPA) located on the bottom of the connector body, use a small flat-blade tool to very carefully raise the TPA on both sides of the connector, view of the TPA when removed from the connector body, and use the J 38125-12A tool to release the terminals by inserting the tool into the left side of the terminal release cavity as shown in the graphic and the tool to move the terminal release to the right with a gentle prying motion. While holding the removal tool in place, gently pull the wire out of the back of the connector, and always remember never to use force when pulling a terminal out of a connector.

You need to use the appropriate terminal and follow the instructions in the J-38125. The location of the terminal in the repair tray and the proper crimp tool can be found in the appropriate connector end view.

You need to remove the auxiliary power outlet fuse from the fuse block and the receptacle. If J 42059 tool fails to release the lighter socket from the retainer, perform the following alternate method: insert a small grinding tool with a cutoff wheel into the socket, remove the plastic latches in the 3 mm (0.11 in) square windows and use the J 42059 as directed above to remove the socket.

You need to squeeze tabs to unsnap the receptacle from the left side rear quarter trim panel and disconnect the electrical connector.

You need to route the connector through the retainer, align the accessory power receptacle retainer to the slot in the opening, install the retainer by pressing it into place fully seated, connect the electrical connector to the receptacle, align the tabs on the receptacle to the slots in the retainer and install the accessory power receptacle by pressing into place until fully seated and the accessory power receptacle fuse.