< Back ×
My Vehicle Change Vehicle
2000 Chevrolet Blazer
< Back to View All
Air Filters & Intake Systems
- Department
- Prices
OEM (Genuine) 2000 Chevrolet Blazer Fuel Injection Air Meter Body
PartNumber: 17113656
Product Specifications- Notes: 4.3L Sfi
- Other Names: Throttle Body
- Item Dimensions: 8.4 x 6.2 x 6.2 inches
- Item Weight: 2.20 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2000 Chevrolet Blazer Fuel Injection Air Meter Body
Vehicle Fitment- 2000 Chevrolet Blazer | LS, LT, Trailblazer | 6 Cyl 4.3 L GAS
FAQ for Throttle Body Repair
Q: What is the recommended torque for the mounting stud and nuts?
A:
The recommended torque is 12 N.m (106 lb in).
By Bob
GM Specialist
02/11/2022Q: What is the recommended circumstance for the accelerator pedal operation?
A:
The accelerator pedal should operate freely without binding between closed and wide open throttle.
By Bob
GM Specialist
02/11/2022Q: How to clean the Throttle Body?
A:
You need to remove the air cleaner outlet. Then you need to inspect the throttle body bore and the throttle valve plate for deposits, and you must open the throttle valve to inspect all of the surfaces. Finally, you need to clean the throttle body bore and the throttle valve plate using a clean shop towel with GM Top Engine Cleaner, P/N 1052626, or an equivalent product.
By Bob
GM Specialist
02/11/2022Q: How to remove the Accelerator Cable?
A:
You need to remove the air cleaner outlet duct and disconnect the accelerator cable from the throttle body. Then you need to remove the accelerator cable and disconnect the accelerator cable from the bracket clip, and you also need to remove the left closeout/insulator panel and remove the accelerator cable from the accelerator pedal. After that, you need to remove the accelerator cable panel insulator retainer, squeeze the accelerator cable tangs and push the cable through the bulkhead. Finally, you can remove the accelerator cable.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the throttle body assembly retaining studs?
A:
The recommended torque is 9 N.m (80 lb in).
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the air cleaner adapter stud?
A:
The recommended torque is 8 N.m (71 lb in).
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the accelerator cable routing bracket nuts?
A:
The recommended torque is 9 N.m (80 lb in).
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the IAC valve mounting screws?
A:
The recommended torque is 3 N.m (27 lb in).
By Bob
GM Specialist
01/11/2022Q: How to remove the IAC valve?
A:
You need to turn OFF the ignition and remove the air cleaner outlet resonator. Then you need to disconnect the idle air control (IAC) valve harness connector. After that, you need to remove the IAC valve mounting screws. Finally, you need to remove the IAC valve and O-ring from the throttle body assembly.
By Bob
GM Specialist
01/11/2022See more FAQs (4)