2000 Chevrolet Tracker Starter

The proper way is to install the starter motor assembly to the vehicle, install the lower mounting bolt, install the upper mounting bolt and the negative battery cable, and then install the air cleaner hose.

The procedure is to install the internal gear to the gear shaft, install the overrunning clutch assembly and the overrunning clutch stop ring to the gear shaft assembly, install the overrunning clutch retaining ring to the gear shaft assembly, install the gear shaft assembly with the pinion drive lever to the drive housing, install the pinion drive lever seal and the plate to the drive housing, install the armature bushing to the armature, install the brush holder assembly to the commutator end, and then install the field coil lead wire and the retaining nut to the solenoid.

The procedure is to remove the starter from the vehicle, remove the retaining nut and the field coil lead wire from the solenoid, remove the two bolts, two screws, and the commutator end cover from the drive housing, remove the brush holder assembly, remove the pinion drive lever from the drive housing, remove the idle gear retainer and three idle gears from the drive housing, remove the gear shaft assembly with the pinion drive lever from the drive housing, and then remove the internal gear from the gear shaft.

The procedure is to remove dirt and burn marks from the commutator end of the armature, inspect the brush holder and the insulation on the positive plates for wear, inspect the pinion drive lever for wear, inspect the overrunning clutch for wear, inspect the commutator end bushing for wear and damage, and then inspect the internal gear assembly and idle gears for wear, damage or other abnormal conditions.

The procedure is to remove the air cleaner hose, remove the retaining nut and positive battery cable from the starter solenoid, and then remove the lower mounting bolt and the starter motor assembly from the vehicle.