< Back ×
My Vehicle Change Vehicle
2000 Chevrolet Tracker
< Back to View All
Trunks & Tailgates
- Department
- Prices
OEM (Genuine) 2000 Chevrolet Tracker Handle, Outside
PartNumber: 30021408
Product Specifications- Notes: 2 Door; 4 Door
- Other Names: Handle, Outside
- Item Dimensions: 6.5 x 4.3 x 4.3 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2000 Chevrolet Tracker Handle, Outside
Vehicle Fitment- 2000 Chevrolet Tracker | Base, LSi, LT, ZR2 | 4 Cyl 1.6 L GAS, 4 Cyl 2.0 L GAS, 6 Cyl 2.5 L GAS
FAQ for Tailgate Handle Repair
Q: How to remove the upper endgate hinge?
A:
The proper way is to open the endgate panel, remove the 2 bolts that retain the endgate upper hinge to the endgate panel, remove the 3 bolts that retain the endgate upper hinge to the door jamb, and then remove the endgate upper hinge from the vehicle.
By Bob
GM Specialist
02/11/2022Q: How to install the upper endgate hinge?
A:
The proper way is to install the endgate upper hinge to the vehicle, install the 2 bolts that retain the endgate upper hinge to the endgate panel, remove the support from the endgate panel, and then close the endgate panel.
By Bob
GM Specialist
02/11/2022Q: How to remove the endgate hinge?
A:
The proper way is to remove the right tail lamp, remove the 4 bolts which secure the endgate lower hinge to the endgate panel, remove the 3 bolts which secure the endgate lower hinge to the door jamb, and then remove the endgate lower hinge from the vehicle.
By Bob
GM Specialist
02/11/2022Q: How to install the endgate hinge?
A:
The proper way is to install the endgate lower hinge to the vehicle, install the 4 bolts which secure the endgate lower hinge to the endgate panel, and then install the right tail lamp.
By Bob
GM Specialist
02/11/2022Q: How to install the endgate handle?
A:
The proper way is to install the endgate outside handle to the rear license plate housing, install the 2 mounting nuts which secure the endgate outside handle, and then install the endgate trim panel seal.
By Bob
GM Specialist
01/11/2022Q: How to remove the endgate handle?
A:
The proper way is to remove the endgate trim panel seal, remove the 2 mounting nuts which secure the endgate outside handle, and then remove the endgate outside handle from the rear license plate housing.
By Bob
GM Specialist
01/11/2022See more FAQs (1)