FAQ for Pillar Panels Repair
Q: How to remove the right-side fourth pillar trim?
A:
You will need to open the rear door(s), remove the screws from the panel in the rear door opening, then release the fasteners that retain the panel to the vehicle, and disconnect the speaker electrical connector if equipped.
By BobGM Specialist
02/11/2022 Q: What's the recommended torque for the cargo net bolt?
A:
The recommended torque is 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 Q: What tools are needed to replace the left body side trim panel?
A:
You will need J 38778 Door Trim Pad and Garnish Clip Remover.
By BobGM Specialist
02/11/2022 Q: What's the installation procedure for the cowl side trim panel?
A:
The installation procedure is to install the trim panel and the screws that retain the trim panel to the cowl side, then tighten the screws that retain the trim panel to the cowl side to 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 Q: What's the removal procedure for the cowl side trim panel?
A:
The removal procedure is to remove the screws that retain the panel to the cowl side, then remove the trim panel.
By BobGM Specialist
02/11/2022 Q: What's the recommended torque for the screw that retains the panel to the C pillar?
A:
The recommended torque is 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 Q: What's the installation procedure for the right side third pillar trim?
A:
The installation procedure is to install the panel to the vehicle, then install the C-pillar retaining screw and tighten the C-pillar retaining screw to 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 Q: What's the installation procedure for the left side third pillar trim?
A:
The installation procedure is to install the panel to the vehicle, then install the retaining screw, tighten the retaining screw to 2 N.m (18 lb in), then install the seat belt upper mount.
By BobGM Specialist
02/11/2022 Q: What's the installation procedure for the?
A:
The installation procedure is to install the garnish molding to the pillar, install the driver's seat belt upper mounting bolt, install the garnish molding retaining screw and tighten the garnish molding retaining screw to 2 N.m (18 lb in).
By BobGM Specialist
02/11/2022 Q: How to install the body side front upper trim panel?
A:
You will need to align the retaining clips with the holes in the body, then press the panel to seat the fasteners into place.
By BobGM Specialist
02/11/2022 See more FAQs (59)