< Back ×
My Vehicle Change Vehicle
2001 Buick Regal
< Back to View All
Ignition, Distributors & ECM
- Department
- Brands
- Prices
OEM (Genuine) 2001 Buick Regal Knock Sensor
PartNumber: 12591625
Product Specifications- Notes: 3.8L;All Models; 3.8L
- Other Names: Knock Sensor
- Item Dimensions: 3.1 x 2.0 x 2.1 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Replaces: 10456215
- Part Description: 2001 Buick Regal Knock Sensor
Vehicle Fitment- 2001 Buick Regal | 25th Anniversary Edition, Custom, Gran Sport, GS, GSE, Limited, LS, LSE, Olympic Gold Edition | 6 Cyl 3.8 L GAS
$67.94 MSRP:$128.20You Save: $60.26 (48%)
Delphi® Ignition Knock Sensor for 2001 Buick Regal
PartNumber: AS10009Product Specifications- UPC: 689604103043
- Part Description: 2001 Buick Regal Ignition Knock Sensor
Vehicle Fitment- 2001 Buick Regal | All Trims | 6 Cyl 3.8L
$48.62
Walker Products® Ignition Knock Sensor for 2001 Buick Regal
PartNumber: 242-1020Product Specifications- Connector Gender: Female
- Connector Quantity: 1
- Connector Shape: Round
- Length: 61 mm
- Mounting Hardware Included: No
- Terminal Gender: Male
- Terminal Quantity: 1
- Terminal Type: Blade
- UPC: 724620074585
- Wiring Harness Included: No
- Part Description: 2001 Buick Regal Ignition Knock Sensor
Vehicle Fitment- 2001 Buick Regal | All Trims | 6 Cyl 3.8L
$36.03
FAQ for Knock Sensor Repair
Q: How to install the knock sensor?
A:
You can install the knock sensor, the knock sensor heat shield, the knock sensor electrical connector to the knock sensor, the splash shield, and fill the cooling system.
By Bob
GM Specialist
01/11/2022Q: What should I pay attention to about the knock sensor?
A:
Awiring pigtail is a wire or wires attached directly to the device (not by a connector). If a wiring pigtail is damaged, you must replace the entire component (with a pigtail). The inflatable restraint steering wheel module coil is an example of a pigtail component.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the knock sensor?
A:
The recommended torque is 60 N.m (44 lb-ft).
By Bob
GM Specialist
01/11/2022Q: How to remove the knock sensor?
A:
You can turn off the ignition switch, raise the vehicle, remove the bolts from the splash shield, drain the cooling system, remove the bolt, the knock sensor wiring harness connector, and the knock sensor.
By Bob
GM Specialist
01/11/2022