< Back ×
My Vehicle Change Vehicle
2001 Chevrolet Venture
< Back to View All
Air Filters & Intake Systems
- Department
- Prices
OEM (Genuine) 2001 Chevrolet Venture Throttle Body Assembly
PartNumber: 12595275
Product Specifications- Notes: 3.4L;All Models; 3.4L
- Other Names: Throttle Body
- Item Dimensions: 7.8 x 5.7 x 5.9 inches
- Item Weight: 2.10 Pounds
- Fitment Type: Direct Replacement
- Replaces: 17113631
- Part Description: 2001 Chevrolet Venture Throttle Body Assembly
Vehicle Fitment- 2001 Chevrolet Venture | Base, LS, LT, Plus, Value, Warner Bros. | 6 Cyl 3.4 L GAS
FAQ for Throttle Body Repair
Q: What should be noticed before installing the accelerator controls cable?
A:
You should notice not to route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary to prevent possible interference and damage to the component.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the bolts?
A:
The recommended torque is 13 N.m (115 lb in).
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the nuts?
A:
The recommended torque is 10 N.m (89 lb in).
By Bob
GM Specialist
02/11/2022Q: How to remove the throttle body assembly?
A:
You need to drain the coolant, remove the air intake duct, disconnect the idle air control (IAC) valve electrical connector, disconnect the throttle position (TP) sensor electrical connector, remove the accelerator control cable bracket, disconnect the throttle body coolant bypass hoses, disconnect the heater pipe nut at the throttle body, remove the nuts and bolts holding the throttle body to the intake manifold, remove the throttle body assembly and the old gasket.
By Bob
GM Specialist
02/11/2022Q: What is the recommended torque for the throttle body retaining nuts and bolts?
A:
The recommended torque is 28 N.m (21 lb-ft).
By Bob
GM Specialist
02/11/2022Q: How to install the accelerator controls cable bracket?
A:
You need to position the accelerator cable bracket on the throttle body, install the nuts and bolts, then install the wire harness into the retainer, and finally install the air intake duct.
By Bob
GM Specialist
02/11/2022Q: What should be noticed before the installation of the throttle body assembly?
A:
You should not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.
By Bob
GM Specialist
02/11/2022Q: How to install the accelerator controls cable?
A:
You need to install the accelerator cable into the car, connect the accelerator cable through the slot in the accelerator pedal lever, seat the snap retainer in the accelerator pedal lever, connect the accelerator cable to the throttle body lever, connect the accelerator cable to the accelerator cable bracket, inspect and check for complete throttle opening and closing positions by operating the accelerator pedal, and also check for poor carpet fit under the accelerator pedal, finally install the left instrument panel sound insulator.
By Bob
GM Specialist
02/11/2022See more FAQs (3)