Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2001 GMC Savana 1500 Brake Caliper

2001 GMC Savana 1500 Brake Caliper

My Vehicle Change Vehicle
2001 GMC Savana 1500
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Brake Pads, Discs & Calipers
  • Department
  • Installation Hardware Included
  • Pads Included
  • Series
  • Brands
  • Prices

8 Products found

4 Q&A for Brake Caliper Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Brake Caliper Repair

Q: What is the recommended torque for the front brake caliper bleeder valve?
A:
The recommended torque is 13 Nm (115-inch lbs.).
By Bob
GM Specialist
29/10/2022
Q: How to compress the front caliper piston?
A:
You need to install a large C-clamp over the top of the caliper housing and against the back of the outboard pad, slowly tighten the C-clamp, and remove the C-clamp from the caliper.
By Bob
GM Specialist
29/10/2022
Q: What is the removal procedure for the brake caliper overhaul?
A:
You need to remove the front brake caliper and the brake caliper piston, remove the caliper piston seal, discard the boot seal, remove and discard the piston seal, remove the bleeder valve and cap, clean the brake caliper piston bore and seal counterbore, and the caliper piston, dry the caliper piston bore and counterbore, and the piston, inspect the caliper bore, and inspect the caliper piston.
By Bob
GM Specialist
29/10/2022
Q: What is the recommended torque for the brake hose to the caliper bolt?
A:
The recommended torque is 50 Nm (37 ft. lbs.).
By Bob
GM Specialist
29/10/2022

FAQ for Other Repair Info

Q: What is the procedure for brake rotor refinishing?
A:
The procedure is to clean the wheel bearing and the wheel bearing hub, measure the thinnest point of the brake rotor, clean the rust from the brake rotor flange, refinish the brake rotor, create a non-directional braking surface, and clean the braking surfaces.
Q: What is the procedure for burnishing pads and rotors?
A:
The procedure is to select a smooth road with little or no traffic, accelerate the vehicle, apply the brakes to bring the vehicle to a stop, and repeat steps until approximately 20 stops have been completed.