2004 Cadillac Escalade EXT Power Seat Switch

After programming is complete, you should move the seat all the way rearward and down, then bump the seat slightly forward and up. This position will be just off the end of travel hard stops. Reset both memory seat exit positions at this position. Having the seat set just off the hard stops will aid in reducing the creep condition.

You need to position the module in the vehicle, connect the lower electrical harness connectors, slide the module to the left to engage the lower retainers, install the module retaining screws, connect the upper electrical harness connectors, and install the seat cushion.

You need to remove the seat cushion, disconnect the upper electrical harness connectors, remove the module retaining screws, slide the module to the right to disengage the lower retainers, disconnect the lower electrical harness connectors, and remove the module from the vehicle.

You should replace the front seat adjuster switch knob. These knobs were formerly available only as part of the power seat adjuster switch. You should not replace the switch if the knob only needs to be replaced.

The memory seat module uses position sensor inputs to establish soft stop locations for the adjuster motors several millimeters ahead of the physical limits of the adjuster assembly. After replacing a memory seat module or adjuster components, it may be necessary to reset the adjuster motor soft stop locations. When the repair procedure has been completed, operate the seat adjuster switch in every direction until the seat adjuster reaches its mechanical hard stop by repeatedly pressing and releasing the switch as necessary.