Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×

2004 Cadillac XLR Transfer Case Output Shaft Bearing

My Vehicle Change Vehicle
2004 Cadillac XLR
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Transfer Cases
  • Department
  • Location
  • Brands
  • Prices

1 Product found

3 Q&A for Transfer Case Output Shaft Bearing Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • National Transfer Case Output Shaft Pilot Needle Bearing for 2004 Cadillac XLR - F-4020
    Product Specifications
    • Notes: w/Getrag 625 Axle; w/8.4646in Ring Gear
    • Bore (Inch): 1.5748
    • Bore (mm): 40.0000
    • Housing Diameter Max (Inch): 1.8501
    • Housing Diameter Max (mm): 46.9925
    • Housing Diameter Min (Inch): 1.8491
    • Housing Diameter Min (mm): 46.9671
    • Outside Diameter (Inch): 1.8496
    • Outside Diameter (mm): 46.9790
    • Shaft Diameter Max (Inch): 1.5748
    • Shaft Diameter Max (mm): 39.9999
    • Shaft Diameter Min (Inch): 1.5742
    • Shaft Diameter Min (mm): 39.9847
    • Type: B
    • Width (Inch): 0.7874
    • Width (mm): 20.0000
    • Part Description: Transfer Case Output Shaft Pilot Needle Bearing
    More Info

FAQ for Transfer Case Output Shaft Bearing Repair

Q: How do you remove the output shaft bearings?
A:
You can remove the case extension housing, and the output shaft flange seal, then use J 5590 to remove the outer output shaft bearing, place J 4513 1-1 onto the inner output shaft bearing, place the case extension on J 45131-2, then insert J 7079-2 into J 4513 1-1 and remove the inner output shaft bearing.
By Bob
GM Specialist
01/11/2022
Q: What's the installation procedure for the output shaft bearings?
A:
The installation procedure is to install the outer output shaft bearing with the numbers on the bearing facing up using J 44762, then install the inner output shaft bearing with numbers on the bearing facing up using J 44762, and install the case extension housing.
By Bob
GM Specialist
01/11/2022
Q: What must be done before servicing a final drive unit on a 4T65-E transaxle?
A:
You will need to ensure that the internal gear thrust bearing (695) is properly seated/located.
By Bob
GM Specialist
01/11/2022