FAQ for Hvac Heater Blend Door Actuator Repair
Q: What is the proper way to install the Air Temperature Actuator?
A:
The proper way is to install the air temperature actuator, the air temperature actuator retaining screws, and the IP insulator.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the Recirculation Actuator (Visteon)?
A:
The proper way is to install the recirculation actuator, the screws, the evaporator core cover, and the HVAC module assembly, and then reprogram the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the Mode Actuator (W/O D07)?
A:
The proper way is to install the mode actuator, the mode actuator mounting screws, the body control module, and the floor air outlet duct extension.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Recirculation Actuator (Delphi)?
A:
The procedure is to remove the air distribution duct, the recirculation actuator retaining screws, and the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the recirculation actuator?
A:
The proper way is to install the recirculation actuator, the recirculation actuator retaining screws, and the air distribution duct.
By BobGM Specialist
01/11/2022 Q: What is the proper way to install the right air temperature actuator?
A:
The proper way is to install the right air temperature actuator, the screws, and the I/P carrier, and then reprogram the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Air Temperature Actuator?
A:
The procedure is to remove the IP insulator, the air temperature actuator retaining screws, and the air temperature actuator.
By BobGM Specialist
01/11/2022 Q: What is the description of the recirculation actuator?
A:
The description is that the HVAC control module controls the air intake through the recirculation actuator. Recirculation is not available when the mode is in defrost. When the mode is in defog, Recirculation will only be available for 10 minutes. The operator must activate the blower for Recirculation operation. The A/C high-pressure recirculation switch can cause the HVAC system to recirculate air. If the recirculation switch is pressed into the ON position when the mode switch is in an unavailable mode position, then the recirculation switch LED will flash 3 times.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Recirculation Actuator (Visteon)?
A:
The procedure is to remove the HVAC module assembly, the screws, the evaporator core cover, and the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure for the Mode Actuator (W/O D07)?
A:
The procedure is to remove the floor air outlet duct extension, the Body Control Module, the mode actuator mounting screws, and the mode actuator as an assembly.
By BobGM Specialist
01/11/2022 See more FAQs (12)