Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2004 GMC Yukon Rack and Pinion Seal

My Vehicle Change Vehicle
2004 GMC Yukon
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Steering Racks & Gearboxes
  • Department
  • Brands
  • Prices

1 Product found

6 Q&A for Rack And Pinion Seal Repair
Sort by:
Recommended
Filter Results
Sort
View by

FAQ for Rack And Pinion Seal Repair

Q: What tool can you use to install the inner pinion-bearing cup into the pinion gear-bearing retainer?
A:
You can use the J 37624 and the J 8092.
By Bob
GM Specialist
02/11/2022
Q: What tool can you use to install a new pinion oil seal?
A:
You can use the J 22388 or the J 44414.
By Bob
GM Specialist
02/11/2022
Q: What is the first step for replacing the drive pinion flange yoke and/or oil seal (All Except 9.75 Inch Axle)?
A:
The first step is to raise the vehicle.
By Bob
GM Specialist
02/11/2022
Q: What tool can you use to install the new seal?
A:
You can use the J 45710.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque when tightening the pinion nut while holding the J 8614-01?
A:
You can tighten the pinion nut to 370 Nm (273 ft. lbs.).
By Bob
GM Specialist
02/11/2022
Q: What tool can you use to remove the inner pinion bearing from the pinion?
A:
You can use the J22912-01 and a hydraulic press.
By Bob
GM Specialist
02/11/2022
See more FAQs (1)

FAQ for Other Repair Info

Q: What can you use to disconnect the brake pipe fitting end from the brake hose?
A:
You can use a backup wrench on the Brake Hose fitting end.
Q: What should you first do when filling the master cylinder reservoir?
A:
You should first visually inspect the brake fluid level through the Brake Master Cylinder reservoir.
Q: What is the removal procedure for the power steering pulley?
A:
The procedure is to remove the following: the upper fan shroud, the drive belt, and the Power Steering Pump pulley.