Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2005 Buick Century Parking Brake Shoe

2005 Buick Century Parking Brake Shoe

My Vehicle Change Vehicle
2005 Buick Century
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
ABS & Parking Brake
  • Department
  • Series
  • Brands
  • Prices

2 Products found

2 Q&A for Parking Brake Shoe Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Parking Brake Shoe Repair

Q: How do you install the Park Brake Shoe?
A:
You need to assemble the park brake shoe to the actuator, install the park brake shoe and actuator onto the backing plate, position the park brake shoe, actuator, and backing plate over the rear hub, install the park brake cable bracket and the two retainers and the rear hub, and install and connect the rear park brake cable to the bracket at the rear wheel, connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel, and then install the rear rotor, the rear caliper bracket, and the rear tire and wheel assemblies.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the Park Brake Shoe?
A:
You need to remove the rear tire and wheel assemblies, relieve the park brake system tension at the equalizer assembly, remove the rear caliper bracket and the rear rotor, disconnect and remove the rear park brake cable from the bracket at the rear wheel, disconnect the park brake cable return spring from the park brake actuator and bracket at the rear wheel, remove the rear hub and the 2 retainers and the park brake cable bracket from the park brake actuator, position the rear hub aside, remove the park brake shoe and actuator from the backing plate and separate the park brake shoe from the actuator.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How do you remove the Electronic Brake Control Module (EBCM)?
A:
You need to turn the ignition switch to the OFF position, remove the front fender upper diagonal brace, and disconnect the accelerator and cruise control cable from the accelerator control cable bracket and the cruise control module from the left strut tower. It is not necessary to remove the cable from the module. Then you can position the module and cables aside, remove the air cleaner intake duct, disengage the red locking tab from the connector lock tab, push down the lock tab and then move the sliding connector cover to the open position, disconnect the electronic brake control module (EBCM) harness connector, remove any dirt/debris from the assembly and the 4 EBCM to brake pressure modulator valve (BPMV) retainers and separate the EBCM from the BPMV by gently pulling apart until separated.
Q: How do you install the Wheel Speed Sensor-Rear?
A:
You need to install the hub and bearing assembly to the vehicle, connect the electrical connector to the rear wheel speed sensor, install the wheel and tire assembly, lower the vehicle, turn the ignition switch to the ON position, with the engine OFF and perform the diagnostic system check-vehicle.