2005 Buick Rainier Floor Pan

For a 1-piece carpet assembly bonded to cotton or fiber padding, you should replace the entire assembly. For a 2-piece carpet assembly with cotton or fiber padding, you should replace the padding only. While the carpet is out of the vehicle, you should dry the carpet using the method described below. For a 1-piece carpet assembly bonded to foam padding or attached to synthetic padding and a 2-piece carpet assembly with synthetic padding, you should use a wet vacuum to remove the excess moisture, blot the face of the carpet with a towel to absorb as much moisture as possible and point a fan at the affected area and air dry the carpet.

GM vehicle care odor eliminator, GM P/N 12378554, US ACDelco 88900909, Canadian P/N 88901678, may control or eliminate odors in the interior and luggage compartment areas of GM vehicles. You may safely use GM vehicle care odor eliminator on fabrics, vinyl, leather, carpet, and sound-deadening materials and you may also induce this product into heating, ventilation, and air conditioning modules and instrument panel ducts for the control of non-bacterial related odors.

You should remove the front bucket seats, the front door sill plates, the center pillar trim panels, the floor console, the floor console bracket, and the carpet from the vehicle.

You should position the carpet to the floor panel, feed the front edge of the carpet underneath the instrument panel, align the holes in the carpet to the seat studs on the floor panel, position the rear carpet over the edge of the front carpet and install the floor console bracket, the floor console, the center pillar trim panels, the front door sill plates, and the front bucket seats.