2005 Chevrolet Blazer Windshield Washer Hose

You need to raise and support the hood, remove the hose from the nozzles, remove the hose clip from the hood, disconnect the hose from the pump, and remove the hose.

You need to install the hose, route the hose out through the bulkhead, route the hose along the body harness, and tape the hose to the body harness with 3 wraps of electrical tape every 100 mm (4 in), seat the hose grommet into the bulkhead, remove the plug from the rear washer pump nozzle, connect the hose to the rear washer pump, install the air cleaner assembly, connect the washer hose connection at the endgate, install the carpet, the left hinge pillar trim panel, the body side trim panel, the left front and left rear door sill plates, the endgate/liftgate door sill plate, the rear seat and the left front seat.

The procedure is to route the hose over the left wheelhouse panel, install the hose to the pump, install the hose to the nozzles, and install the hose clip to the hood, then close the hood.