Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2005 Chevrolet Classic Window Channel

My Vehicle Change Vehicle
2005 Chevrolet Classic
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Windows & Components
  • Department
  • Prices

3 Products found

7 Q&A for Window Channel Repair
Sort by:
Recommended
Filter Results
Sort
View by

FAQ for Window Channel Repair

Q: What should be done before servicing the Window Regulator Handle?
A:
You should remove the spring clip by inserting the J 9886-01 between the window regulator handle and the door window regulator handle bearing plate.
By Bob
GM Specialist
02/11/2022
Q: What should be done before servicing the Window Run Channel?
A:
You should remove the front door trim panel.
By Bob
GM Specialist
02/11/2022
Q: What special tool will I be needing when servicing the Window Regulator Handle?
A:
You will be needing door handle clip remover.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the window run channel bolts?
A:
The recommended torque is 10 N.m (89 lb in).
By Bob
GM Specialist
02/11/2022
Q: Should I replace the rear window reveal molding as an assembly?
A:
The rear window reveal molding may be replaced with the rear window as an assembly, or the rear window reveal molding may be available as a separate service part.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when servicing the Windshield Frame Header Panel?
A:
If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1 1/2 in) apart.
By Bob
GM Specialist
01/11/2022
Q: What will need to be disabled when servicing the Windshield Frame Header Panel?
A:
You will need to disable the SIR system.
By Bob
GM Specialist
01/11/2022
See more FAQs (2)

FAQ for Other Repair Info

Q: What is the removal procedure for the Window Regulator Motor?
A:
Remove the front door water deflector. Disconnect the front door window regulator electrical connector. Press the front door Window Motor retaining tabs out to release the front door window regulator motor from the front door system locking module. Remove the front door window regulator from the front door system locking module.
Q: Can I service the front door window regulator separately?
A:
The front door Window Regulator is part of the front door locking system module and can not be serviced separately.
Q: How do you remove the power window switch bezel?
A:
You can remove the power Window Switch bezel from the power window switch by releasing the retainers with the flat-bladed tool.