2006 Chevrolet Corvette Alloy Wheels

The procedure is to install the rear Parking Brake Cable, install the rear parking brake cable retainer nut, connect the rear park brake cable to the rear suspension mounting bracket, connect the rear park brake cable to the retainer and equalizer, and install the RH muffler, then enable the park brake automatic adjuster.

You need to install the Steering Knuckle to the upper control arm and the lower control arm, install the steering linkage outer tie rod ball stud to the steering knuckle, install the stabilizer shaft link to the lower control arm, connect the wheel speed sensor electrical connector, install the brake rotor and caliper, the tire and wheel assembly. Check the front wheel toe and adjust as necessary.

The procedure is to remove the Brake Master Cylinder, secure the mounting flange of the brake master cylinder in a bench vise, clean the outside of the master cylinder reservoir on and around the reservoir cap, remove the reservoir cap and diaphragm from the reservoir, inspect the reservoir cap and diaphragm for cuts or cracks, nicks or deformation, remove the master cylinder reservoir from the master cylinder, depress the primary piston and remove the piston retainer, remove the primary piston assembly, plug the cylinder inlet ports and the rear outlet port, and discard the primary piston assembly, the piston retainer, and the seals and seal retainer from the secondary piston.