2006 Chevrolet Corvette Fuel Tank Pressure Sensor

The procedure is to apply a small amount of clean motor oil to the O-rings, install the Fuel Injector in the fuel rail, install the retaining clips for the fuel injector, reconnect the electrical connector for the fuel injector, install the fuel rail assembly, and inspect for leaks.

You need to remove the left fuel tank and the fuel fill hose from the fuel tank and cap the open end of the fuel tank.

You need to remove the module from the fuel tank, press on the connector position assurance (CPA) with your thumb and slide downward, disconnect the electrical connector from the module, remove the sender wires from the connector, push in the lock tab above the level sender body and slide the level sender out of the slot, and remove the level sender from the module.