2006 Chevrolet Corvette Parking Brake Cable

You need to install the Steering Knuckle to the upper control arm and the lower control arm, install the steering linkage outer tie rod ball stud to the steering knuckle, install the stabilizer shaft link to the lower control arm, connect the wheel speed sensor electrical connector, install the brake rotor and caliper, the tire and wheel assembly. Check the front wheel toe and adjust as necessary.

The procedure is to remove the Brake Master Cylinder, secure the mounting flange of the brake master cylinder in a bench vise, clean the outside of the master cylinder reservoir on and around the reservoir cap, remove the reservoir cap and diaphragm from the reservoir, inspect the reservoir cap and diaphragm for cuts or cracks, nicks or deformation, remove the master cylinder reservoir from the master cylinder, depress the primary piston and remove the piston retainer, remove the primary piston assembly, plug the cylinder inlet ports and the rear outlet port, and discard the primary piston assembly, the piston retainer, and the seals and seal retainer from the secondary piston.

You need to remove the clutch actuator cylinder, remove the roll-pin retaining the Hydraulic Hose to the actuator cylinder, remove the hydraulic hose from the actuator cylinder, and drain off the excess fluid from the actuator cylinder into a container.