FAQ for Pillar Panels Repair
Q: What is the installation procedure for the Trim Panel-Rear Compartment Front Side?
A:
The procedure is to position the trim panel within the vehicle, feed the seat belt through the opening in the panel, push inward on the panel until the retaining clips engage, install the seat belt escutcheon in the trim panel, and install the seat belt anchor bolt to the seat, then install the lift window strut.
By BobGM Specialist
02/11/2022 Q: What is the installation procedure for the Trim-Lock Pillar?
A:
The procedure is to install the lock pillar trim, push on the trim to engage the retainers, position the seat fully rearward, and install the door sill plate.
By BobGM Specialist
02/11/2022 Q: How to remove the Trim-Lock Pillar?
A:
You need to remove the door sill plate, position the seat fully forward, and remove the lock pillar trim by grasping the trim panel at the bottom and working upward to disengage the retainers from the body and remove the lock pillar trim.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the seat belt anchor bolt?
A:
The recommended torque is 9 Nm (80 lb in).
By BobGM Specialist
02/11/2022 Q: What is the installation procedure for the Trim-Hinge Pillar?
A:
The procedure is to snap the hinge pillar trim to the hinge pillar, install the fastener attaching the top of the trim, and install the lower trim panel (sill plate) if removed.
By BobGM Specialist
02/11/2022 Q: How to install the Trim Panel-Rear Compartment Front Side?
A:
You need to position the trim panel within the vehicle, feed the seat belt through the opening in the panel, push inward on the panel, install the seat belt escutcheon in the trim panel, install the seat belt anchor bolt to the seat, and install the lift window strut.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the roof lift-off panel stowage front anchor plate screws?
A:
The recommended torque is 8 Nm (71 Ib in).
By BobGM Specialist
02/11/2022 Q: How to remove the Windshield Upper Garnish Molding?
A:
You need to remove the windshield side garnish moldings, the inside rearview mirror, and remove the sunshades, then grasp the upper garnish molding and pull the garnish molding with its retainers from the windshield frame.
By BobGM Specialist
02/11/2022 Q: How to remove the Trim Panel-Rear Compartment Front Side?
A:
You need to remove the lift window strut, the seat belt anchor bolt, and the seat belt escutcheon, disengage the clips securing the panel, feed the seat belt through the opening in the panel, then remove the panel.
By BobGM Specialist
02/11/2022 Q: How many push-pin retainers does Trim Panel Carpet-Rear Compartment Rear Center have?
A:
It has a total of 2 push-pin retainers.
By BobGM Specialist
02/11/2022 See more FAQs (20)