< Back ×
My Vehicle Change Vehicle
2006 Chevrolet Equinox
< Back to View All
Ignition, Distributors & ECM
- Department
- Prices
OEM (Genuine) 2006 Chevrolet Equinox Cylinder Kit, Ignition Lock (Uncoded)
PartNumber: 19120481
Product Specifications- Notes: 3.4 Liter, 2005-06
- Other Names: Ignition Cylinder, Ignition Lock Cylinder
- Item Dimensions: 6.3 x 3.3 x 3.2 inches
- Item Weight: 0.50 Pounds
- Fitment Type: Direct Replacement
- Replaces: 89022872
- Replaced by: 15841209
- Part Description: 2006 Chevrolet Equinox Cylinder Kit, Ignition Lock (Uncoded)
Vehicle Fitment- 2006 Chevrolet Equinox | LS, LT | 6 Cyl 3.4 L GAS
$15.57 MSRP:$37.04You Save: $21.47 (58%)
FAQ for Ignition Lock Cylinder Repair
Q: What is the recommended torque for the ignition lock cylinder screws?
A:
The recommended torque is 2.5 (22-inch lbs.).
By Bob
GM Specialist
01/11/2022Q: How to remove the ignition lock cylinder?
A:
You can remove the steering wheel, the steering column trim covers, the multifunction levers, the lock housing bolts, the ignition switch screws, and the ignition switch.
By Bob
GM Specialist
01/11/2022Q: How to remove the ignition switch lock cylinder?
A:
You can disable the supplemental inflatable restraint, remove the steering column trim covers, insert the key into the ignition, rotate to the RUN position, and then rotate the ignition cylinder back to the ACC position.
By Bob
GM Specialist
01/11/2022Q: Why is the ignition lock cylinder hard to turn/bind?
A:
Because a lack of lubrication may cause adjoining metal surfaces to wear, resulting in a significant amount of powder (black) forming in the ignition cylinder case housing.
By Bob
GM Specialist
01/11/2022Q: How to service the key and lock cylinder coding?
A:
For the key cutting and lock cylinder coding procedure, you can refer to the instruction sheet supplied in the key and lock cylinder kit.
By Bob
GM Specialist
01/11/2022Q: What is the installation procedure for the ignition switch lock cylinder?
A:
The procedure is to install the lock cylinder assembly, install the cylinder into the lock housing, rotate the lock cylinder in the housing, install the SIR system and then connect the negative battery cable.
By Bob
GM Specialist
01/11/2022Q: How to install the repair ignition lock cylinder case?
A:
You can install the screws, the multifunction levers, the steering column trim covers, the supplemental inflatable restraint (SIR) coil, and the steering wheel.
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the lower bolts and the upper bolts?
A:
The recommended torque is 8 (71-inch lbs.).
By Bob
GM Specialist
01/11/2022Q: How to correct the situation where the ignition lock cylinder is hard to turn/binds?
A:
You should contact Technical Assistance (TAC). Remove the ignition lock cylinder, clean the ignition lock cylinder and case housing, use two different General Motors (GM) lubricants, remove the battery cover, disconnect the negative battery cable, and then remove the ignition lock cylinder.
By Bob
GM Specialist
01/11/2022See more FAQs (4)