< Back ×
My Vehicle Change Vehicle
2006 Chevrolet Monte Carlo
< Back to View All
Ignition, Distributors & ECM
- Department
- Prices
OEM (Genuine) 2006 Chevrolet Monte Carlo Case
PartNumber: 19149552
Product Specifications- Other Names: Case, Ignition Lock
- Item Dimensions: 6.2 x 5.4 x 5.1 inches
- Item Weight: 1.60 Pounds
- Fitment Type: Direct Replacement
- Replaces: 19133760
- Part Description: 2006 Chevrolet Monte Carlo Case
Vehicle Fitment- 2006 Chevrolet Monte Carlo | LS, LT, LTZ, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
$59.04 MSRP:$111.42You Save: $52.38 (48%)
OEM (Genuine) 2006 Chevrolet Monte Carlo Cylinder Kit, Ignition Lock
PartNumber: 15794826
Product Specifications- Item Dimensions: 3.2 x 2.2 x 1.8 inches
- Item Weight: 0.70 Pounds
- Fitment Type: Direct Replacement
- Replaces: 25756079, 19120038
- Part Description: 2006 Chevrolet Monte Carlo Cylinder Kit, Ignition Lock
Vehicle Fitment- 2006 Chevrolet Monte Carlo | LS, LT, LTZ, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
FAQ for Ignition Lock Cylinder Repair
Q: What should you perform after the ignition lock cylinder has been replaced?
A:
You should perform passkey relearn.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the ignition lock cylinder case?
A:
The procedure is to disable the SIR system, remove the ignition lock cylinder, the ignition switch, the steering column tilt head components, the turn signal switch housing, the turn signal, and multifunction switch assembly, the park lock cable assembly, the 3 TORX screws and the ignition lock cylinder case.
By Bob
GM Specialist
01/11/2022Q: How do you install the ignition lock cylinder case?
A:
You can align the ignition lock cylinder case with the steering column tilt head assembly, screw the 3 TORX screws into the ignition lock cylinder case, press the locking tab on the end of the park lock cable assembly into the slot, install the turn signal switch housing, the turn signal and multifunction switch assembly, the steering column tilt head components, the ignition switch, and the ignition lock cylinder and enable the SIR system.
By Bob
GM Specialist
01/11/2022Q: What should you remove before replacing the ignition lock cylinder?
A:
You should remove the tilt lever, the steering wheel, and the steering column trim covers.
By Bob
GM Specialist
01/11/2022