2006 GMC Yukon Cup Holder

You need to remove the radio amp fuse, the floor console bezel, the cupholder, the bolts retaining the console to the I/P, the console storage bin, the Center Console end panel, and the 4 screws retaining the upper console bracket to the lower console bracket, move both front seats to the full forward, reposition the inboard seat track trim to gain access to the rear console side panel screw, remove both rear console side panel screws, move both front seats to the fully rearward, remove both front console side panel screws, disconnect the floor console electrical connector, and remove the console assembly.

You need to remove the front nuts and the front seat trim panel, unsnap the lumbar cable, disconnect the lumbar wire harness and the electrical connectors, remove the pressure sensor from the front passenger seat frame, lift the seat cushion off the rear plastic holders on the underside of the seat cushion, and pull forward, remove the seat switch bezel and the lumbar actuator, unclip the seat trim cover from the seat cushion frame, separate the seat cushion trim cover from the Seat Cushion Pad, and remove the pad from the seat cushion frame and the seat cushion heater element.

You need to use the J 38778 to remove the rear upper garnish molding, insert the J 38778 and work along the front edge of the trim panel from one end to the other, and remove the rear upper garnish molding from the vehicle.