2006 GMC Yukon Fender Splash Shield

You need to remove the radio amp fuse located, the floor console bezel, the cupholder, the bolts retaining the console to the I/P, the console storage bin, the Center Console end panel, and the 4 screws retaining the upper console bracket to the lower console bracket, move both front seats to the full forward, reposition the inboard seat track trim to gain access to the rear console side panel screw, remove both rear console side panel screws, move both front seats to the fully rearward, remove both front console side panel screws, disconnect the floor console electrical connector, and remove the console assembly.

You need to remove the console Cup Holder assembly and the 2 retaining screws, slide the blower assembly upwards, insert a small flat-bladed tool to release the tab that secures the connector in place, and remove the blower from the cupholder assembly.

The Door Hinge pins and bushings are not replaceable. If the hinge pins or bushings are damaged, replace the door hinge as an assembly.