Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2007 Buick Lucerne Air Hose

My Vehicle Change Vehicle
2007 Buick Lucerne
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Air Filters & Intake Systems
  • Department
  • Brands
  • Prices

1 Product found

2 Q&A for Air Hose Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • Monroe Rear Shock Absorber Air Hose Kit for 2007 Buick Lucerne - AK29

    Monroe® Rear Shock Absorber Air Hose Kit for 2007 Buick Lucerne

    PartNumber: AK29
    $23.65
    Product Specifications
    • Attribute: Air Shock Single Fill Kit
    • UPC: 048598932242
    • Part Description: 2007 Buick Lucerne Rear Shock Absorber Air Hose Kit
    More Info
    Vehicle Fitment
    • 2007 Buick Lucerne | All Trims | All Engines

FAQ for Air Hose Repair

Q: What should you do before driving the vehicle?
A:
Turn the ignition on and wait approximately 45 seconds. This will ensure that the air-adjustable shock absorbers are filled with residual pressure.
By Bob
GM Specialist
01/11/2022
Q: What should be done before disconnecting any air tube?
A:
Clean the connector and the surrounding area to prevent dirt and other foreign material from entering the ELC system.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the installation procedure for the Throttle Body Assembly?
A:
Install the Throttle Body and seal. Apply thread lock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the nuts. Install the throttle body nuts. Tighten the throttle body bolts/nuts. Connect the engine harness electrical connector. Install the AIR feed tube. Install the air cleaner outlet duct.
Q: What is the installation procedure for the Automatic Level Control Air Compressor Air Filter?
A:
Connect the air hose to the air compressor assembly at two places. Connect the intake Air Filter to the air hose and the body rail. Install the heat shield and the harness tie with three bolts. Install the air compressor connector. Lower the vehicle.
Q: What is the installation procedure for the Manifold Absolute Pressure Sensor?
A:
Ensure that the seal is installed on the MAP Sensor and that the seal is not damaged. Position and install the MAP sensor. Ensure that the locking tabs engage to hold the MAP sensor. Connect the engine harness electrical connector. Install the intake manifold cover.