2007 Buick Rainier Parking Brake Shoe

You should install the park brake cables over the fuel tank assembly, the park brake cable retaining nuts to the underbody mounting studs, the rear support bracket for the fuel tank, remove the pole jack and the block of wood from the fuel tank, install the park brake cable on the actuator, the park brake retainer to the frame (left rear shown), the parking brake retaining bracket bolt in the frame, the Parking Brake Cable to the park brake cable retainers, the shield for the fuel tank, the park brake cables to the retainer, the park brake cables to the park brake equalizer, and the rear propeller shaft.

You should install the 3 retaining clamps as noted, install the NEW power steering gear oil seal to the power steering gear, the Power Steering Hose assembly to the vehicle, the power steering hose assembly to frame brackets retaining bolts, the power steering hose assembly bracket to the wheel well, the power steering hose assembly bracket retaining bolt at the wheel well, the upper fuse block assembly to lower fuse block, the upper fuse block bolts, the fuse block cover, the battery tray, the power steering hose assembly to front crossmember bracket mounting bolt, the power steering cooler hose to the power steering pump, the power steering pressure hose to the power steering pump, the power steering return hose and the power steering cooler hose to the power steering cooler as shown, the power steering hose assembly to power steering gear retaining bolt, and the engine protection shield.

You should install the Steering Knuckle to the lower control arm, a new lower ball joint retaining nut, a new upper control arm pinch bolt and nut, the brake hose bracket to the steering knuckle, the brake hose bracket retaining bolts, the outer tie rod to the steering knuckle, the new outer tie rod retaining nut, the wheel hub and bearing the tire and wheel and the drive axle nut.