2007 Buick Rendezvous Brake Pad Set

After removing brake fluid to the midway point, you can raise and suitably support the vehicle, remove the tire and the wheel assembly, compress the rear caliper piston and remove the upper caliper bolt. Then you can rotate the caliper downward, remove the pads and the two retainer slides, and replace any damaged parts.

You need to remove the brake fluid to the midway point before proceeding. Then you can raise and support the vehicle, remove the tire and wheel, and install two-wheel nuts and a C-clamp. After tightening the C-clamp, you can remove the C-clamp and the lower brake caliper bolt and rotate the brake caliper. Then you can remove the brake pads and the brake pad retainers. After installing a C-clamp, you need to tighten the C-clamp, remove the C-clamp, and inspect for any corrosion or damage.

You need to install the two retainer slides and the pads. Then you need to remove the support and reposition the caliper. After lubricating the bolt and the bolt boot, you need to install the upper caliper bolt, remove the two-wheel lug nuts, install the tire and the wheel assembly and lower the vehicle. After applying and releasing the brake pedal, you can fill the brake master cylinder reservoir and burnish the pads and rotors.

You need to install the four brake pad retainers and the brake pads. After cleaning and applying Threadlocker GM P/N 12345493, you can pivot the caliper down onto the pads, install the lower caliper bolt and remove the two-wheel nuts. Then you can install the tire and wheel, lower the vehicle and pump the brake pedal. After that, you can fill the master cylinder and burnish the pads and the rotors.

Failure to adhere to these precautions could lead to serious personal injury and vehicle damage.