2007 Buick Terraza Sliding Door Roller

You can install the sliding door lower roller bracket to the lower door bracket, the sliding door lower roller bracket to the grease pencil marks on the sliding door, the sliding door lower roller bracket bolts, the support from the sliding door, the front edge of the sliding door inner trim panel to the sliding door, the PSD system by installing the PSD 15A fuse into the I/P fuse block, the sliding door, and the trim panel access plug.

The recommended torque is 10 N.m (89 lb in).

You can remove the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block, the trim panel access plug, the sliding door, the sliding door lower roller bracket vertical bolts, and the sliding door lower roller bracket from the lower track.

You can attach the cable ends, position the sliding door center roller bracket to the front radius of the sliding door center track, lower the sliding door center roller bracket to the sliding door center track down and into the sliding door center track, install the cable to the rear roller bracket, the sliding door center roller bracket, open and close the rear sliding door to verify the door fit and the door latch/unlatch operation, and test the cable tension again after manually moving the door.

You can remove the sliding door garnish molding, and the headliner trim finish molding, support the sliding door, mark the location of the sliding door upper roller bracket, remove the sliding door upper roller bracket bolts, and the sliding door upper roller bracket from the front edge of the upper track.