Notes: Fuel tank contamination is the leading cause of premature fuel pump failure. To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. Use of fuel tank cleaning kit FC01 is recommended.
Current Draw: 7
Flow Rating: 26 gph
Fuel Level Sender Assembly Included: Yes
Fuel Type: Gas
Gasket or Seal Included: Yes
In Tank or External: In Tank
Inlet Type: Strainer
Internal or External Strainer: External
Item Grade: Standard Replacement
Maximum Pressure: 94.0 PSI
Outlet Outside Diameter: 0.375''
Outlet Quantity: 2
Outlet Type: Quick Connect
Pump Type: Electric
Regulator Included: Yes
Resistance Ohms Empty: 40.0
Resistance Ohms Full: 250.0
Strainer Included: Yes
System Pressure: 58 psi
Terminal Gender: Male
Terminal Quantity: 4
Terminal Type: Blade
UPC: 689604266885
Vapor Pressure Sensor: No
Voltage: 12.0 VDC
Part Description: 2007 Cadillac CTS Fuel Pump Module Assembly
Notes: Fuel tank contamination is the leading cause of premature fuel pump failure. To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. Use of fuel tank cleaning kit FC01 is recommended.
Fuel Level Sender Assembly Included: Yes
Fuel Type: Gas
Gasket or Seal Included: Yes
In Tank or External: In Tank
Item Grade: Standard Replacement
Package Contents: Fuel Transfer Unit with Float Arm, Seal, Instruction Sheet
Regulator Included: No
Resistance Ohms Empty: 40.0
Resistance Ohms Full: 250.0
Strainer Included: No
Terminal Gender: Male
Terminal Quantity: 4
Terminal Type: Pin
UPC: 689604265147
Vapor Pressure Sensor: No
Part Description: 2007 Cadillac CTS Fuel Tank Sending Unit
Part Description: 2007 Cadillac CTS Electric Fuel Pump
More Info
Vehicle Fitment
2007 Cadillac CTS | All Trims | 6 Cyl 3.6L
2007 Cadillac CTS | All Trims | 6 Cyl 2.8L
2007 Cadillac CTS | All Trims | 8 Cyl 6.0L
Show More
FAQ for Fuel Pump Repair
Q: What should be done if routine diagnosis using SI does not reveal any obvious cause?
A:
Reprogram the ECM with updated calibration files using the TIS2WEB Service Programming System (SPS) application.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the Primary Fuel Level Sensor Replacement?
A:
Install the Fuel Level Sensor by aligning the tabs of the sensor with the slots and sliding the sensor fully into position, and the primary fuel tank module.
Q: What is the removal procedure for the Fuel Tank Pressure Sensor?
A:
Raise and support the vehicle, disconnect the Fuel Tank Pressure Sensor electrical connector, and remove the fuel tank pressure sensor.
Q: What is the proper way to install the Filler Tube?
A:
Connect the filler hose and the filler vent tube, and install the rear bumper fascia, the right rear wheel, and the fuel filler cap.