< Back ×
My Vehicle Change Vehicle
2007 Cadillac DTS
< Back to View All
Cameras & Driver Safety
- Department
- Prices
OEM (Genuine) 2007 Cadillac DTS Reverse Sensor
PartNumber: 15239247
Product Specifications- Notes: Dts; Front Object;Dts; Rear Object
- Other Names: Alarm, Park Sensor, Reverse Sensor, Sensor
- Item Dimensions: 4.8 x 2.3 x 1.9 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Replaces: 19116085
- Part Description: 2007 Cadillac DTS Reverse Sensor
Vehicle Fitment- 2007 Cadillac DTS | Base, Luxury, Platinum | 8 Cyl 4.6 L GAS
$162.05 MSRP:$244.48You Save: $82.43 (34%)
FAQ for Parking Sensors Repair
Q: What is the proper way to install the Rear Object Senso?
A:
The proper way is to insert the sensor into the housing, connect the electrical connector to the rear object sensor, and then install the rear bumper fascia.
By Bob
GM Specialist
02/11/2022Q: What is the removal procedure for the Rear Object Senso?
A:
The procedure is to remove the rear bumper fascia, disconnect the electrical from the rear object sensor, and then lift the locking tabs on the housing and remove the rear object sensor.
By Bob
GM Specialist
02/11/2022Q: What is the removal procedure for the front object alarm sensor?
A:
The procedure is to remove the front bumper fascia, disconnect the electrical, and then lift the locking tabs on the housing and remove the front object sensor.
By Bob
GM Specialist
02/11/2022Q: What is the proper way to install the front object alarm sensor?
A:
The proper way is to insert the sensor into the housing, connect the electrical connector to the front object sensor, and then install the front bumper fascia.
By Bob
GM Specialist
02/11/2022Q: What is the procedure for the Rear Object Sensor Housing replacement?
A:
The procedure is to remove the rear fascia, disconnect the sensor harness, remove the sensor from the sensor housing, sand/grind sonic weld plastic residue, install the sensor housing, and the sensor, connect the electrical harness and then install the rear fascia.
By Bob
GM Specialist
02/11/2022Q: What should be done before replacing the Front and Rear Object Alarm Modules?
A:
You should remove the right side trim panel and refer to control module references for replacement and setup information.
By Bob
GM Specialist
01/11/2022See more FAQs (1)