Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2007 Cadillac DTS Washer Reservoir

My Vehicle Change Vehicle
2007 Cadillac DTS
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Wipers & Washers
  • Department
  • Prices

1 Product found

3 Q&A for Washer Reservoir Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2007 Cadillac DTS Washer Reservoir - 10367083
    OEM 2007 Cadillac DTS Washer Reservoir Diagram - 10367083
    View Related Parts

    OEM (Genuine) 2007 Cadillac DTS Washer Reservoir

    PartNumber: 10367083
    Product Specifications
    • Other Names: Washer Reservoir
    • Item Dimensions: 7.9 x 6.6 x 25.8 inches
    • Item Weight: 1.60 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2007 Cadillac DTS Washer Reservoir
    More Info
    Vehicle Fitment
    • 2007 Cadillac DTS | Base, Livery, Luxury, Platinum, Premium | 8 Cyl 4.6 L GAS

FAQ for Washer Reservoir Repair

Q: What should be done before replacing the Washer Solvent Container?
A:
You should remove the right front wheelhouse panel liner, drain the washer solvent, and then disconnect the electrical connector.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the windshield washer solvent container nuts?
A:
The recommended torque is 6 Nm (53 LB in).
By Bob
GM Specialist
01/11/2022
Q: How many nuts does the windshield washer solvent container have?
A:
The windshield washer solvent container has 3 nuts.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the recommended torque for the Wiper Blade Element?
A:
You should position the Wiper Blade at a mid-wipe on the windshield, cycle the ignition key to the off position, and then raise the wiper blade off the glass.
Q: What is the removal procedure for the fuse?
A:
The procedure is to disconnect the negative battery cable, locate the underhood bussed electrical center, remove the UBEC cover and the 60 amp heated windshield washer fuse, connect the negative battery cable, test the operation of the windshield wiper system, close the hood, and then make a copy of the Owner Manual Supplement, located at the back of this bulletin, and place it in the glove box.
Q: What is the removal procedure for the Windshield Outside Moisture Sensor?
A:
The procedure is to gently pry the trim cover outward, remove the trim cover, release the windshield coupler retaining clips, remove the rain sensor module, and then disconnect the electrical connector.