Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2007 Cadillac Escalade ESV Ignition Lock Cylinder

My Vehicle Change Vehicle
2007 Cadillac Escalade ESV
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Ignition, Distributors & ECM
  • Department
  • Brands
  • Prices

4 Products found

2 Q&A for Ignition Lock Cylinder Repair
Sort by:
Recommended
Filter Results
Sort
View by

FAQ for Ignition Lock Cylinder Repair

Q: How do you remove the Ignition Lock Cylinder Case?
A:
You need to disable the SIR system, remove the inflatable restraint steering wheel module coil, the ignition/start switch, and the park lock cable from the lock cylinder housing, disconnect the passlock and key buzzer from the ignition lock cylinder case and remove 3 TORX(R) screws and the ignition lock cylinder case from the steering column.
By Bob
GM Specialist
01/11/2022
Q: How do you install the Ignition Lock Cylinder Case?
A:
You need to position the ignition lock cylinder housing to the steering column and install the 3 TORX(R) screws, install the park lock cable into the lock cylinder housing, connect the passlock and key buzzer to the ignition lock cylinder case, install the ignition/start switch and the inflatable restraint steering wheel module coil and enable the SIR system.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the proper way to install the ignition coil?
A:
The proper way is to position the Ignition Coil to the ignition coil bracket, install the ignition coil bolts, and the spark plug wire to the ignition coil, connect the ignition coil wiring harness electrical connector to the ignition coil and install the intake manifold sight shield.
Q: How do you install the knock sensor 1?
A:
You need to position the Knock Sensor to the engine block and install the knock sensor bolt, connect the engine wiring harness electrical connector to the knock sensor, and install the left front wheel and tire.
Q: How do you remove the engine control module?
A:
You need to use a scan tool, retrieve the percentage of remaining engine oil and record the remaining engine oil life. Next, you can disconnect the negative battery cable, disengage the engine wiring harness upper electrical connector retainer and remove the connector from the ECM, the engine wiring harness lower electrical connector retainer and remove the connector from the ECM and the retainer tabs securing the ECM to the bracket and remove the ECM.