< Back ×
2007 Chevrolet Colorado Accelerator Pedal Position Sensor
My Vehicle Change Vehicle
2007 Chevrolet Colorado
< Back to View All
Engine Sensors, Switches & Relays
- Department
- Prices
OEM (Genuine) 2007 Chevrolet Colorado Pedal Travel Sensor
PartNumber: 25955673$131.00 MSRP:$247.20You Save: $116.20 (48%)Product Specifications- Notes: Canyon, Colorado
- Other Names: Pedal Travel Sensor
- Item Dimensions: 15.2 x 5.3 x 5.5 inches
- Item Weight: 1.00 Pounds
- Fitment Type: Direct Replacement
- Replaces: 10376526
- Part Description: 2007 Chevrolet Colorado Pedal Travel Sensor
Vehicle Fitment- 2007 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
FAQ for Accelerator Pedal Position Sensor Repair
Q: What is the recommended torque for the APP sensor mounting nuts?
A:
The recommended torque is 9 N.m (80 lb in).
By Bob
GM Specialist
01/11/2022Q: What is the recommended torque for the nuts retaining the sensor to the floor panel?
A:
The recommended torque is 9 N.m (80 lb in).
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the Accelerator Pedal Position Sensor?
A:
You should position the APP sensor over the studs, install the APP sensor nuts, connect the APP sensor electrical connector, and inspect below the pedal for binding to ensure the full range of motion.
By Bob
GM Specialist
01/11/2022Q: What is the proper way to install the Longitudinal Accelerometer?
A:
You should install the sensor to the vehicle, install the 2 retaining nuts, install the electrical connector to the sensor, and install the left split bench or bucket seat.
By Bob
GM Specialist
01/11/2022Q: How to remove the Accelerator Pedal Position Sensor?
A:
You need to disconnect the accelerator pedal position (APP) sensor electrical connector, then remove the APP sensor nuts and the APP sensor from the vehicle.
By Bob
GM Specialist
01/11/2022Q: How to remove the Longitudinal Accelerometer?
A:
You need to remove the left split bench or bucket seat, access the sensor through the service slit provided in the carpet, then remove the electrical connector from the sensor, remove the 2 nuts retaining the sensor to the floor panel, then remove the sensor from the vehicle.
By Bob
GM Specialist
01/11/2022See more FAQs (1)