< Back ×
My Vehicle Change Vehicle
2007 Chevrolet Colorado
< Back to View All
Driveline, Axles & 4WD
- Department
- Prices
OEM (Genuine) 2007 Chevrolet Colorado Boot Kit, Front Wheel Drive Shaft Cv Joint (Inboard & Outboard)
PartNumber: 89040354
Product Specifications- Notes: 4WD; Canyon, Colorado
- Location: Driver Side; Passenger Side
- Other Names: Outer Boot
- Item Dimensions: 7.6 x 6.9 x 6.8 inches
- Item Weight: 2.20 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2007 Chevrolet Colorado Boot Kit, Front Wheel Drive Shaft Cv Joint (Inboard & Outboard)
Vehicle Fitment- 2007 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
OEM (Genuine) 2007 Chevrolet Colorado Boot Kit, Front Wheel Drive Shaft Double Offset Joint (Outboard)
PartNumber: 89040355
Product Specifications- Notes: 4WD; Canyon, Colorado
- Location: Driver Side; Passenger Side
- Other Names: Inner Boot
- Item Dimensions: 6.1 x 4.4 x 4.2 inches
- Item Weight: 1.50 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2007 Chevrolet Colorado Boot Kit, Front Wheel Drive Shaft Double Offset Joint (Outboard)
Vehicle Fitment- 2007 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
FAQ for Cv Joint Boot Repair
Q: What kind of special tools will be required when serving the Wheel Drive Shaft Outer Joint and Seal?
A:
The tools required include J 35910 Drive Axle Seal Clamp Plier and J 8059 Snap Ring Pliers.
By Bob
GM Specialist
01/11/2022Q: Can you reuse the small or the large retaining clamp?
A:
No, you should discard them.
By Bob
GM Specialist
01/11/2022Q: How to remove the Wheel Drive Shaft Outer Joint and Seal?
A:
You need to remove the inner seal, use a hand grinder to cut through the large retaining clamp located at the C/V joint, and use a hand grinder to cut through the small retaining clamp on the small end of the outer seal, then remove the outer seal from the C/V joint, and clean the old grease out of the C/V joint and allow to thoroughly dry.
By Bob
GM Specialist
01/11/2022