Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2007 Chevrolet Corvette Fuse Box

My Vehicle Change Vehicle
2007 Chevrolet Corvette
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Fuses & Fuse Box
  • Department
  • Prices

1 Product found

4 Q&A for Fuse Box Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2007 Chevrolet Corvette Junction Block Diagram - 21996326
    View Related Parts

    OEM (Genuine) 2007 Chevrolet Corvette Junction Block

    PartNumber: 21996326
    $475.54 MSRP: $755.01
    You Save: $279.47 (38%)
    Product Specifications
    • Notes: Fuse Box, Engine Compartment
    • Other Names: Junction Block
    • Item Dimensions: 12.1 x 10.0 x 5.4 inches
    • Item Weight: 3.90 Pounds
    • Fitment Type: Direct Replacement
    • Replaces: 10355736
    • Part Description: 2007 Chevrolet Corvette Junction Block
    More Info
    Vehicle Fitment
    • 2007 Chevrolet Corvette | Base, Z06 | 8 Cyl 6.0 L GAS, 8 Cyl 7.0 L GAS

FAQ for Fuse Box Repair

Q: What is the removal procedure for the Underhood Electrical Center or Junction Block?
A:
The procedure is to remove the junction block cover, disengage the electrical cable retainers, the engine wiring harness connector, and the I/P wiring harness connector, and remove the junction block.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to install the Underhood Electrical Center or Junction Block?
A:
The proper way is to connect the I/P wiring harness connector, install the junction block cover and the positive battery cable lead, and connect the negative battery cable.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the Instrument Panel Electrical Center or Junction Block?
A:
The procedure is to disconnect the negative battery cable, remove the right door sill plate and the battery cable lead, and disconnect three 64-way block connectors and 3 I/P wiring harness connectors.
By Bob
GM Specialist
01/11/2022
Q: What is the installation procedure for the Instrument Panel Electrical Center or Junction Block?
A:
The procedure is to install the electrical wiring junction block to the multi-use bracket, the battery cable lead, the passenger side carpet, and the right door sill plate.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: What is the proper way to install the Starter Motor?
A:
The proper way is to install the Starter motor, the starter motor S terminal washer and purple lead wire, the gray and rust harness leads, the positive battery cable terminal, and the right catalytic converter.
Q: What should be noticed while servicing the Power Seat Switch Knob?
A:
You shall pull outward to remove the Power Seat Switch Knob.
Q: What should be noticed while removing the Tire Pressure Sensor Grommet?
A:
If any tire sealant is noted upon tire dismounting, you shall replace the sensor and all residual liquid sealant from the inside of the tire and wheel surfaces.