2007 Chevrolet Equinox Tie Rod End

You may need to apply approximately 3/4 of the supplied grease packet into the small end of the boot cavity and apply the remainder of the grease on the shaft where the small end of the boot meets the shaft, then install the boot with the large clamp loosely attached, not crimped, then crimp the large clamp, install the spring clamp to the small end of the boot and the jam nut approximately 174 mm (6.85 in) from the boot clamp, finally install the outer tie rod and the tire assembly, then check the front wheel alignment and align as necessary.

You will need to remove the outer tie rod and the jam nut, then remove the spring from the boot, outer end, then cut and remove the crimp clamp, inner end, next unseat the boot from the steering gear and remove, finally clean the inner tie rod and boot contact area of grease and debris.