Part Description: 2007 GMC Sierra 3500 Classic Driveshaft Center Support Bearing
More Info
Vehicle Fitment
2007 GMC Sierra 3500 Classic | All Trims | 8 Cyl 6.0L
2007 GMC Sierra 3500 Classic | All Trims | 8 Cyl 6.6L
2007 GMC Sierra 3500 Classic | All Trims | 8 Cyl 8.1L
Show More
FAQ for Driveshaft Center Support Bearing Repair
Q: How to remove the propeller shaft center support bearing?
A:
The proper way is to remove the propeller shaft, stand the propeller shaft on the end in the press with the center bearing supported by the press bars, press the propeller shaft down and off the center bearing, and remove the center bearing.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What should be noticed before installing the rear axle shaft (8.6, 9.5/9.5LD inch axles)?
A:
You shall carefully insert the Axle Shaft to not damage the seal.
Q: What is the removal procedure for the front axle lubricant?
A:
The proper way is to remove the engine shield, clean the area around the front axle fill plug and the drain plug, remove the fill plug and the drain plug, and drain the fluid from the front Differential carrier assembly.
Q: How to remove the rear axle shaft seal and/or bearing (w/rear disc)?
A:
You shall remove the tire and wheel assembly, the rear axle housing cover, the axle shaft, the Axle Shaft Seal, and the bearing from the axle housing.