2008 Buick Enclave Fuel Filler Hose

You need to install new Fuel Injector seals, the fuel injector, the fuel injector retainer clip, and the fuel injector electrical connector, push down on the fuel injector electrical connector retainer, install the fuel rail with fuel injectors to the lower intake manifold, the fuel rail bolts, and the upper intake manifold, connect the fuel feed pipe quick connect fitting to the fuel rail and the engine wiring harness electrical connector to the fuel injector wiring harness electrical connector, and then install the fuel injector sight shield.

You need to position the Fuel Level Sensor to the module bucket and slide the sensor down, ensure that the fuel level sensor tabs engage the module bucket, install the fuel level sensor wiring under the module clip, connect the fuel level sensor electrical connector to the module cover, and then install the fuel tank module.

You need to remove the fuel tank, disconnect the fuel pump fuel feed line quick connect fitting from the fuel tank module and evaporative emission (EVAP) canister vent front pipe quick connect fitting from the fuel tank module, reposition the fuel pump fuel feed line and the EVAP canister vent front pipe out of the way, disconnect the fuel sender wiring harness electrical connector from the fuel tank pressure sensor and the fuel sender wiring harness electrical connector from the fuel tank module, install the J 45722 to the fuel tank module lock ring, rotate the lock ring counterclockwise unlocking the fuel tank module lock ring, remove the J 45722 and the fuel tank module lock ring, raise the module, tilt the module towards the lower front corner of the fuel tank to allow the level sensor float arm to clear the tank opening, remove the module from the fuel tank, discard the fuel in the module reservoir bucket into an approved container, and then remove and discard the fuel tank module seal and the fuel level sensor.