< Back ×
2008 Buick LaCrosse HVAC Control Module
My Vehicle Change Vehicle
2008 Buick LaCrosse
< Back to View All
A/C & Heating
- Department
- Prices
$11.55 MSRP:$20.88You Save: $9.33 (45%)Product Specifications- Notes: Lacrosse; Instrument Panel, Park Lamp
- Item Dimensions: 3.8 x 2.2 x 0.7 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Replaces: 12193606, 19115080, 15328866, 12135034, 15393412, 12088567, 12135170, 19116057
- Part Description: 2008 Buick LaCrosse AC Relay
Vehicle Fitment- 2008 Buick LaCrosse | Avenir, Base, Convenience, CX, CXL, CXS, Essence, Leather, Preferred, Premium, Sport Touring, Super, Touring | 4 Cyl 2.4 L GAS, 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 4 Cyl 2.5 L MILD HYBRID EV-GAS (MHEV), 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 8 Cyl 5.3 L GAS
FAQ for Hvac Control Module Repair
Q: How do you install the HVAC control module?
A:
You can connect the electrical connectors, and install the HVAC control module, the mounting screws, and the lower trim plate.
By Bob
GM Specialist
01/11/2022Q: How do I remove the Heater and Air Conditioning Control?
A:
Start with removing the instrument panel lower trim plate. Next, remove the HVAC control assembly mounting screws and pull the HVAC control assembly rearward from the instrument panel. Next, disconnect the electrical connectors from the HVAC control assembly and remove the HVAC control assembly.
By Bob
GM Specialist
01/11/2022Q: What is the removal procedure for the HVAC control module?
A:
The procedure is to remove the I/P trim plate, the HVAC control module screws, and the HVAC control module.
By Bob
GM Specialist
01/11/2022Q: How do I install the Heater and Air Conditioning Control?
A:
First, you will need to connect the electrical connectors to the HVAC control assembly. Next, install the HVAC control assembly by tightening the screws to 2 Nm (18 lb in). Then install the instrument panel lower trim plate. Lastly, start the engine for one minute.
By Bob
GM Specialist
01/11/2022Q: How do I remove the blower motor control module?
A:
Start with removing the right side instrument panel (I/P) insulator, and disconnect the electrical connector from the blower control module. Remove the 2 heat stakes from the blower control module using a small chisel and remove the blower motor control module.
By Bob
GM Specialist
01/11/2022