Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Buick LaCrosse Parking Sensors

My Vehicle Change Vehicle
2008 Buick LaCrosse
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Cameras & Driver Safety
  • Department
  • Prices

1 Product found

5 Q&A for Parking Sensors Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2008 Buick LaCrosse Back Up Sensor - 89047027
    OEM 2008 Buick LaCrosse Back Up Sensor Diagram - 89047027
    View Related Parts

    OEM (Genuine) 2008 Buick LaCrosse Back Up Sensor

    PartNumber: 89047027
    Product Specifications
    • Notes: Backup Sensor
    • Other Names: Back Up Sensor, Sensor
    • Item Dimensions: 4.3 x 4.3 x 2.2 inches
    • Item Weight: 0.60 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2008 Buick LaCrosse Back Up Sensor
    More Info
    Vehicle Fitment
    • 2008 Buick LaCrosse | CX, CXL, CXS, Super | 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 8 Cyl 5.3 L GAS

FAQ for Parking Sensors Repair

Q: What should you do before replacing the rear object sensor?
A:
You should remove the rear fascia from the vehicle.
By Bob
GM Specialist
02/11/2022
Q: How do you install the info center telltale?
A:
You can connect the electrical connector, place the center telltale into the headliner, and install the bezel.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the object alarm module?
A:
The procedure is to remove the rear shelf trim panel, disconnect the RPA electrical connector, and remove the fasteners.
By Bob
GM Specialist
01/11/2022
Q: How do you install the object alarm module?
A:
You can install the RPA receiver, the receiver fastener, and the rear window trim panel.
By Bob
GM Specialist
01/11/2022
Q: What is the proper way to remove the info center telltale?
A:
The proper way is to pull down the bezel retainers, release the locking tabs, and disconnect the electrical connectors.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How do I install the power mirror switch?
A:
Start with installing the electrical connector to the power Mirror Switch and press the switch into the retainer plate. Lastly, install the front door trim panel.
Q: How do you remove the starter shield?
A:
You can remove the fasteners, the Starter heat shield, and the heat shield mounting bracket.
Q: How do you install the battery current sensor?
A:
You can slide the new Battery Sensor into the battery cable, install the battery cable, and connect the electrical connector.