Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Cadillac CTS Oil Pressure Sensor

My Vehicle Change Vehicle
2008 Cadillac CTS
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Engine Sensors, Switches & Relays
  • Department
  • Brands
  • Prices

3 Products found

3 Q&A for Oil Pressure Sensor Repair
Sort by:
Recommended
Filter Results
Sort
View by

FAQ for Oil Pressure Sensor Repair

Q: What is the recommended torque for the oil pressure sensor?
A:
The recommended torque is 20 N.m (15 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to install the Engine Oil Pressure Sensor and Switch?
A:
First, you need to install the oil pressure sensor. Then, please connect the oil pressure sensor electrical connector.
By Bob
GM Specialist
01/11/2022
Q: How to remove the Engine Oil Pressure Sensor and Switch?
A:
First, you need to turn the ignition OFF. Then, please disconnect the oil pressure sensor electrical connector. Finally, you should remove the oil pressure sensor.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How to install the Crankshaft Position Sensor?
A:
First, you need to install the Crankshaft Position Sensor and the crankshaft position sensor bolt. Then, please connect the CKP electrical connector. Finally, you should install the wiring harness heat shield to the oil level indicator tube and lower the vehicle.
Q: How should the Accelerator Pedal Position Sensor be handled?
A:
You should use cleanliness to prevent damage. Do not drop the electronic throttle control components or roughly handle the electronic throttle control components. Please don't immerse the electronic throttle control components in cleaning solvents of any type.
Q: What is the removal procedure of the camshaft position sensor-bank 1 (right side) exhaust?
A:
First, you need to turn the ignition OFF and remove the front compartment sight shields as necessary. Then, please disconnect the camshaft position (CMP) sensor electrical connector. Finally, you should remove the CMP sensor bolt and the CMP sensor.