Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Cadillac SRX A/C Receiver Drier

My Vehicle Change Vehicle
2008 Cadillac SRX
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
A/C & Heating
  • Department
  • Prices

1 Product found

2 Q&A for A/C Receiver Drier Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2008 Cadillac SRX Drier Desiccant Bag Diagram - 89023442
    View Related Parts

    OEM (Genuine) 2008 Cadillac SRX Drier Desiccant Bag

    PartNumber: 89023442
    $40.15 MSRP: $75.78
    You Save: $35.63 (48%)
    Product Specifications
    • Other Names: Dehydrator, Drier, Drier Desiccant Bag, Plug
    • Item Dimensions: 4.2 x 4.1 x 13.1 inches
    • Item Weight: 1.20 Pounds
    • Fitment Type: Direct Replacement
    • Replaced by: 86551901
    • Part Description: 2008 Cadillac SRX Drier Desiccant Bag
    More Info

FAQ for A/C Receiver Drier Repair

Q: How to remove the Air Conditioning Refrigerant Desiccant?
A:
You should recover the refrigerant, raise and support the vehicle, remove the front air deflector retainers, the front air deflector, and the desiccant bag plug, record the amount of any lost PAG oil from the desiccant bag and remove the desiccant bag.
By Bob
GM Specialist
28/10/2022
Q: How to install the Air Conditioning Refrigerant Desiccant?
A:
You should install the desiccant bag, lubricate the O-ring on the desiccant bag plug, install the desiccant bag plug, the front air deflector, and the front air deflector retainers, lower the vehicle, add the proper amount of oil, evacuate and recharge the refrigerant and leak test the fittings of the component with J 39400-A.
By Bob
GM Specialist
28/10/2022

FAQ for Other Repair Info

Q: How to install the Auxiliary Blower Motor?
A:
You should install the Blower Motor to the HVAC module and the blower motor screws, tighten the screws, connect the blower motor electrical connector and install the left body side trim access panel.
Q: How to remove the Heater Core?
A:
You should remove the HVAC module, the Heater Core pipe bracket screw, the heater core pipe bracket, and the heater core from the HVAC module.
Q: How to remove the Heater Inlet Hose (LY7-Gas, 6 Cylinder, 3.6L, SFI, V6)?
A:
You should drain the cooling system, remove the battery tray, the cowl panel retaining bolts, and the cowl panel, use J 38185 to slide the clamp away from the base of the heater inlet hose, remove the inlet Heater Hose from the heater core, use J 38185 slide the clamp away from the base of the heater inlet hose and remove the clamp and hose from the engine cooling thermostat assembly.