2008 Cadillac XLR Door Lock Actuator

You should install the power Door Lock Switch to the armrest switch plate applique, and the lock switch assembly into the pocket in the door trim panel, remove any protective tape, install the armrest to the door trim panel, the inner energy absorber to the door panel, the upper trim to the door, the retainers at the back of the door trim panel, and the door trim panel.

You should remove both trim plugs from the fastener sockets of the floor-mounted door release, the pushpin from the front seat riser cover, which is nearest to the floor-mounted door release, both fasteners from the door release, the door sill trim, the B-Pillar interior trim. the mastic cover from the door latch access hole in the body, the fasteners from the B-Pillar mounted door latch, and the latch from the body access hole. Remove the latch cover fasteners from the rear of the latch, the latch cover, and the cable end by rotating the cable a quarter turn to disengage from the latch actuating lever.

The recommended torque is 25 N.m (18 lb-ft).