Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Cadillac XLR Suspension Control Module

My Vehicle Change Vehicle
2008 Cadillac XLR
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Air Suspension
  • Department
  • Prices

1 Product found

1 Q&A for Suspension Control Module Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2008 Cadillac XLR Module Asm-Electronic Suspension Control - 15808061
    OEM 2008 Cadillac XLR Module Asm-Electronic Suspension Control Diagram - 15808061
    View Related Parts

    OEM (Genuine) 2008 Cadillac XLR Module Asm-Electronic Suspension Control

    PartNumber: 15808061
    Product Specifications
    • Notes: Xlr
    • Other Names: Control Module, Module
    • Item Dimensions: 10.4 x 6.9 x 2.9 inches
    • Item Weight: 2.30 Pounds
    • Fitment Type: Direct Replacement
    • Replaces: 15229333, 25814227, 10367688
    • Part Description: 2008 Cadillac XLR Module Asm-Electronic Suspension Control
    More Info
    Vehicle Fitment
    • 2008 Cadillac XLR | Base, Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS

FAQ for Suspension Control Module Repair

Q: How to remove the Electronic Suspension Control (ESC) Module?
A:
You should disconnect the electrical connector, release the 2 locking tabs on the bottom of the bracket, and raise the ESC upward to release the upper arms to remove and reprogram the ESC module.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How to install the Parking Brake Rear Cable?
A:
You should install the rear Parking Brake Cable to the vehicle, the rear parking brake cable retainer nut, and the RH muffler.
Q: How to install the Steering Column Lock Control Module?
A:
You should install the control module to the retaining bracket on the Steering Column, connect the electrical connector to the lock module and install the I/P carrier.
Q: How to install the Steering Knuckle?
A:
You should install the Steering Knuckle to the upper control arm and the lower control arm, remove the jack stand, and install the steering linkage outer tie rod ball stud to the steering knuckle, the stabilizer shaft link to the lower control arm, the brake rotor, the caliper, and the tire and wheel assembly.