Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Chevrolet Avalanche Fuel Pressure Sensor

My Vehicle Change Vehicle
2008 Chevrolet Avalanche
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Fuel Systems
  • Department
  • Prices

1 Product found

3 Q&A for Fuel Pressure Sensor Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2008 Chevrolet Avalanche Tank Pressure Sensor Diagram - 12247409
    View Related Parts

    OEM (Genuine) 2008 Chevrolet Avalanche Tank Pressure Sensor

    PartNumber: 12247409
    $49.25 MSRP: $92.95
    You Save: $43.70 (48%)
    Product Specifications
    • Notes: W/Flex Fuel
    • Other Names: Pressure Sensor, Tank Pressure Sensor
    • Item Dimensions: 3.2 x 2.1 x 2.0 inches
    • Item Weight: 0.40 Pounds
    • Fitment Type: Direct Replacement
    • Replaces: 88965447
    • Part Description: 2008 Chevrolet Avalanche Tank Pressure Sensor
    More Info
    Vehicle Fitment
    • 2008 Chevrolet Avalanche | LS, LT, LTZ | 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS

FAQ for Fuel Pressure Sensor Repair

Q: How do I install the Fuel Tank Pressure Sensor?
A:
Install the sensor and then install the fuel tank.
By Bob
GM Specialist
07/03/2022
Q: How do I remove the Fuel Tank Pressure Sensor?
A:
Start with removing the fuel tank, then disconnect the EVAP line fitting from the vent valve and reposition it out of the way. Use a slight rocking motion while pulling up to remove the sensor.
By Omar
GM Specialist
06/03/2022
Q: What is the fuel pressure sensor installation procedure?
A:
First, lubricate a new fuel pressure sensor O-ring seal with clean engine oil and install it onto the fuel line fitting. Install the fuel pressure sensor and tighten the sensor to 15 Nm. Next, connect the chassis wiring harness electrical connector to the fuel pressure sensor.
By Omar
GM Specialist
01/03/2022

FAQ for Other Repair Info

Q: What is the fuel injector installation procedure?
A:
Install the new Fuel Injector upper/lower O-ring seals, the fuel injectors into the fuel rails, and the retainers. Install the fuel rail bolts and tighten the bolts to 10 Nm. Next install the EVAP tube, purge solenoid, and the canister purge solenoid. After that install the PVC hose, and the negative battery cable stud and tighten the stud to 25 Nm. Install the engine wiring harness bracket nut and tighten the nut to 5 Nm. Finally, install the air cleaner outlet duct.
Q: What is the fuel lever sensor installation procedure?
A:
First, connect the Fuel Level Sensor electrical connectors and install the fuel level sensor to the module. Next place the fuel level sensor down until the retainers engage the sensor and install the fuel tank module.