2008 Chevrolet Aveo A/C Clutch

The proper way is to invert the pulley rotor and place it on a support block to fully support the rotor hub during bearing installation, align the new bearing squarely in the pulley bore, place the J 33019 and the J 33019 in the rotor hub core, strike the pin with a hammer until a metal stake, similar to the original, is formed down to, but not touching, the bearing, position the J 33017 and the J 33023-A directly over the inner race of the bearing, install the rotor and the bearing assembly retainer ring using the J 6083, install the compressor, and then evacuate and recharge the A/C system.

The proper way is to place the clutch coil assembly on the compressor housing with the terminals positioned at the marked location, install the J 42428 through-bolts and the washers through the crossbar slots, install the clutch rotor and bearing assembly, install the clutch plate and hub assembly, install the compressor, connect the negative battery cable, and then evacuate and recharge the A/C system.

The proper way is to disconnect the negative battery cable, remove the compressor, remove the clutch drive plate and hub assembly, remove the pulley rotor and the bearing assembly retaining ring using the J 6083, remove the puller bolt from the J 33020, and then drive the bearing out of the rotor hub with the J 9398-A and the J 8092.

The proper way is to disconnect the negative battery cable, recover the refrigerant, remove the compressor, remove the clutch plate and hub assembly, remove the clutch rotor and bearing, mark the clutch coil terminal location on the compressor housing, install the J 33023-A on the compressor housing, install the J 8433-1 with the J 33025, and then tighten the J 8433-3 against the J 33023-A to remove the clutch coil.