Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Chevrolet Aveo License Plate Lights

My Vehicle Change Vehicle
2008 Chevrolet Aveo
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Warning Lights, Interior Lights & Other Lights
  • Department
  • Prices

1 Product found

2 Q&A for License Plate Lights Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2008 Chevrolet Aveo License Lamp - 95387158
    OEM 2008 Chevrolet Aveo License Lamp Diagram - 95387158
    View Related Parts

    OEM (Genuine) 2008 Chevrolet Aveo License Lamp

    PartNumber: 95387158
    Product Specifications
    • Notes: Sedan,
    • Item Dimensions: 7.9 x 4.3 x 2.3 inches
    • Item Weight: 0.60 Pounds
    • Fitment Type: Direct Replacement
    • Replaces: 96312748
    • Part Description: 2008 Chevrolet Aveo License Lamp
    More Info
    Vehicle Fitment
    • 2008 Chevrolet Aveo | Base, LS, LT, Special Value | 4 Cyl 1.6 L GAS

FAQ for License Plate Lights Repair

Q: How to install the rear license lamp?
A:
The proper way is to install a new bulb, connect the electrical connector, install the lamp assembly with the screws, and then tighten the license plate lamp screws to 1.5 N.m (13 lb in).
By Bob
GM Specialist
01/11/2022
Q: How to remove the rear license lamp?
A:
The proper way is to remove the screws, disconnect the electrical connector, remove the lamp assembly, and then remove the bulb.
By Bob
GM Specialist
01/11/2022

FAQ for Other Repair Info

Q: How to install the starter motor?
A:
The proper way is to place the Starter assembly in position, install the upper and the lower starter mounting bolts, position the starter electrical wire on the solenoid terminal, install the starter solenoid nuts, and then connect the negative battery cable.
Q: How to install the tire pressure indicator sensor?
A:
The proper way is to assemble the new tire pressure sensor snap-in enclosure to the valve stem and install a new Torx screw, install the tire to the wheel, and then install the tire and wheel assembly to the vehicle.
Q: How to install the repeater lamp?
A:
The proper way is to connect the electrical connector, install the side turn signal lamp, and then connect the negative battery cable.