Search Bar
Search by Part Number, Part Name, or Vehicle
  • My Garage
  • Cart
  • OE Parts
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Shop OE Parts
  • Shop By Category
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting

2008 Chevrolet Aveo Turn Signal Lights

My Vehicle Change Vehicle
2008 Chevrolet Aveo
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Signal Lights
  • Department
  • Prices

1 Product found

2 Q&A for Turn Signal Lights Repair
Sort by:
Recommended
Filter Results
Sort
View by
  • OEM 2008 Chevrolet Aveo Repeater Lamp - 96499649
    OEM 2008 Chevrolet Aveo Repeater Lamp Diagram - 96499649
    View Related Parts

    OEM (Genuine) 2008 Chevrolet Aveo Repeater Lamp

    PartNumber: 96499649
    Product Specifications
    • Notes: Sedan,
    • Location: Driver Side; Passenger Side
    • Other Names: Repeater Lamp
    • Item Dimensions: 3.5 x 2.4 x 2.5 inches
    • Item Weight: 0.30 Pounds
    • Fitment Type: Direct Replacement
    • Part Description: 2008 Chevrolet Aveo Repeater Lamp
    More Info
    Vehicle Fitment
    • 2008 Chevrolet Aveo | LS, LT, Special Value | 4 Cyl 1.6 L GAS

FAQ for Turn Signal Lights Repair

Q: How to install the repeater lamp?
A:
The proper way is to connect the electrical connector, install the side turn signal lamp, and then connect the negative battery cable.
By Bob
GM Specialist
02/11/2022
Q: How to remove the repeater lamp?
A:
The proper way is to disconnect the negative battery cable, slide the side turn signal lamp rearward, remove the lamp, and then disconnect the electrical connector.
By Bob
GM Specialist
02/11/2022

FAQ for Other Repair Info

Q: How to install the starter motor?
A:
The proper way is to place the Starter assembly in position, install the upper and the lower starter mounting bolts, position the starter electrical wire on the solenoid terminal, install the starter solenoid nuts, and then connect the negative battery cable.
Q: How to install the tire pressure indicator sensor?
A:
The proper way is to assemble the new tire pressure sensor snap-in enclosure to the valve stem and install a new Torx screw, install the tire to the wheel, and then install the tire and wheel assembly to the vehicle.
Q: How to install the inflatable restraint steering wheel module coil?
A:
The proper way is to install the clock spring to the steering shaft, install the new screws, install the driver-side knee bolster or instrument panel lower cover, install the upper and lower steering column covers, install the screws, and then install the steering wheel.