< Back ×
My Vehicle Change Vehicle
2008 Chevrolet Colorado
< Back to View All
Ignition, Distributors & ECM
- Department
- Prices
OEM (Genuine) 2008 Chevrolet Colorado Cylinder & Keys
PartNumber: 89022365
Product Specifications- Notes: W/Tilt
- Other Names: Cylinder & Keys, Ignition Lock Cylinder
- Item Dimensions: 5.8 x 4.6 x 1.7 inches
- Item Weight: 0.60 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2008 Chevrolet Colorado Cylinder & Keys
Vehicle Fitment- 2008 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
$29.13 MSRP:$48.23You Save: $19.10 (40%)
FAQ for Ignition Lock Cylinder Repair
Q: What is the installation procedure for the Ignition Lock Cylinder Case?
A:
Install the ignition lock cylinder case. Install the ignition lock cylinder case bolt and tighten it until the head shears off. Install the multifunction turn signal switch. Install the ignition lock cylinder.
By Omar
GM Specialist
17/02/2022Q: What is the installation procedure for the Ignition Lock Cylinder?
A:
Turn the ignition lock cylinder to the accessory position. Push the ignition lock cylinder in until the retaining pin locks it in place. Install the steering column trim covers.
By Bob
GM Specialist
17/02/2022Q: What is the removal procedure for the Ignition Lock Cylinder Case?
A:
Remove the ignition lock cylinder. Remove the multifunction turn signal switch housing. Remove the shear bolt. Remove the ignition lock cylinder case.
By Bob
GM Specialist
12/02/2022Q: What is the removal procedure for the Ignition Lock Cylinder?
A:
Remove the steering column trim covers. Turn the ignition lock cylinder to the accessory position. Insert the 90-degree tip of a pick-type tool into the ignition lock cylinder access hole. Push and hold the ignition lock cylinder retaining pin down. Pull the ignition lock cylinder away from the steering column.
By Omar
GM Specialist
12/02/2022Q: What should you do after the code has been determined from the code list or the key code diagram?
A:
Cut a blank key to the proper level of each of the tumbler positions. Inspect the key operation in the lock cylinder.
By Omar
GM Specialist
09/02/2022Q: What tool will I be needing when assembling and coding Ignition Lock Cylinders?
A:
You will be needing an ignition lock holding fixture.
By Bob
GM Specialist
09/02/2022See more FAQs (1)