2008 Chevrolet Corvette Fuel Level Sensor

You should insert the new level sender assembly into the slot, slide down until the lock tab engages, route wires next to the regulator ground wire and up to the electrical connector, slide the level sender wires into the open slots in the electrical connector, connect the electrical connector into the flange, test the level sender resistance with an ohmmeter, install the module into the tank, measure the resistance across the level sender with tank upright, roll the tank over and then return the tank to the upright position.

You should remove the module from the fuel tank, press on the 3-connector position assurance (CPA) lock tabs and slide downward, disconnect the electrical connector from the module, remove the sender wires from the connector, push in the lock tab above the level sender body and slide the level sender out of the slot and then remove the level sender from the module.